工業用高頻感應加熱機故障案例分析

六、故障排除：故障排除troubleshooting

故障現象The fault phenomenon	故障原因The cause of the problem	排除方法 Elimination method
無 電 源 顯 示 No electrical source display	1.空氣開關控制開關未合上The air switch control switch is not closed 2.控制保險絲斷 The control fuse is blown 3.空氣開關或控制開關損壞Air switch or control switch damaged 4.其他原因 Other reasons	1.合上開關 Close the switch 2. 更換保險絲 Replace fuse 3. 更換 replace 4.與廠家聯系維修Contact the manufacturer for repair
啟動不起來（即按啟動按鈕后，電流顯示為“0”，機器聲響很快，約幾秒又自動停止）Can not start up (that is, after pressing the start button, the current display is "0", the machine sounds very fast, and stops automatically in about a few seconds)	1.感應圈兩圈間短路Short circuit between induction rings 2.感應圈連接頭松動Loose connection of induction coil 3.感應圈接頭處有生料帶There is raw tape at the induction ring joint 4.設備故障Equipment failure	1.整修感應圈 Refit the induction ring 2.上緊感應圈螺帽Tighten the induction ring nut 3.清除生料帶 Remove raw material strips 4.與廠家聯系維修Contact the manufacturer for repair
可以啟動，有電流顯示但不加熱或加熱很慢Can be started, with current display but not heated or heated very slowly	感應圈兩圈間短路Short circuit between induction rings	整修感應圈 Refit the induction ring
工作時報警Working alarm	參見面板指示說明See panel instructions
工作即報警，反復多次現象一樣Work that alarm, repeatedly many times	設備故障Equipment failure	與廠家聯系維修Contact the manufacturer for repair

發布于2022/3/15 9:24:17